All posts by Qincy – MA Lighting

dot2 Tips+Tricks No.44 [EN] Follow mode offset values

Hello everybody out there,
here comes our next Tips & Tricks clip!
In this one, we quickly talk about the use of the Follow mode in dot2 onPC and dot2 3D and how to give the follow target offset values.
This can be used to follow artists on stage in an exact height- so something really useful for live performances.
Of cause you can use this to do quicker position presets.
Have a look!
Cheers,
Qincy

dot2 Tips+Tricks No.43 [EN] Changing Fixture types defaults

Hi there,
Welcome to our first Tips & Tricks clip in 2018!
We received some questions about the behavior of Fixtures and how to change it.
In our example, we change the default Zoom angle as well as the default Tilt position of a fixture and
Change the exsisting Fixture in our Show against the modificated one.
Have a look!
Cheers,
Qincy

dot2 Tips+Tricks No.41 [EN] Timecode Part 1 – setup !

Hello again,

we´ve some more clips for you, today it´s all about timecode triggering of Cues in the dot2.
In our first Clip, we explain what timecode is about and how to set your dot2 up for this.
Cheers,
Qincy

dot2 tips and tricks – No. 40 – Basics for Effects no.6: syncing effects

Hello everybody,

today, in our tips and tricks series, we talk about synchronizing effects- first about syncing two effects over differnent fixture types,
as well as two effects parallel on the same fixtures. In here, we also use what we we have learned before about the width and the phase angles.
So: get in sync!
Cheers,
Qincy

dot2 tips and tricks – No. 39 – Basics for Effects no.5 again: Phase!

Hello again,

in this tips and tricks clip for dot2, we talk again about the phase angle.
We show show on what basis the console spreads the phase angle out in default and how you can use the align function for that.

Cheers,
Qincy

dot2 tips and tricks – No. 38 – Basics for Effects no.4- the Phase

Hello out there,

Again we continue our clips about the basics of effects.
One of the most important values that decide about the look of your effect is the phase.
So this time we talk about the Phase and explain what it is and how to check.

Cheers,
Qincy

dot2 tipps und tricks – no. 37 – effekt grundlagen nr.3

Hallo zusammen,
dieses Video setzt unsere kleine Serie über die Grundlagen von Effekten fort.
Wir erklären die Nummerierung der Effektvorlagen sowie das Verhältnis zwischen den Wertänderungen.
Am Ende des Clips besprechen wir die High- und Low-Werte.
Schauts Euch an!
Euer Qincy

dot2 tips and tricks – no. 37 – basics for effects no.3

Hello everybody,
This clip continues our little series about the basics of effects.
We explain the effect template numbering as well as the relation between the value changes,
by using the effect template no. 1.
At the end of the clip, we talk about low and high values.
Have a look!
Cheers,
Qincy